Specifications:

Charging voltage:16.8v ~ 18.1v

Over Charge voltage:4.25±0.05v

Over Discharge voltage: 2.5v±0.05v

Continuous discharge current (upper limit): 40A (if the heat dissipation environment is not good, please reduce the load current )

Continuous charge current (upper limit): 20A

Internal resistance: Less than 100mΩ

Applications:

It is suitable for lithium batteries with nominal voltage of 3.7V and full voltage of 4.2V (including 18650, 26650, polymer lithium batteries, no size limit).Besides, it can use for electric drill with starting current below 80A and power below 135W .

Note:

1.Do not deliberately make it short circuit.Please strictly according to the diagram wiring to avoid possible damage to the chip. (Connect wires refer to the "wiring diagram"(NO.5 picture).

2.When the battery for the first time, do not connect any load or equipment to the output.After connection, it need to charge activation first, then will have the output.

3.Do not mix good batteries with bad ones.

4.The closer the internal resistance of the 4 battery capacities is the better.

5.When using a brush motor type load, try to connect a non-polar capacitor (withstand voltage above 25V, capacity 10uF-100uF) in parallel with the positive and negative terminals of the motor to prevent the reverse spike voltage generated by the motor from interfering with the protection board or breakdown of the MOS tube.

Package inlcudes:

2x 4S 40A lithium Battery Protection Board

Current Rating	40 Amps
Input Voltage	240 Volts
Output Voltage	16.8 Volts (DC)
Item Weight	0.02 Kilograms
Color	4S 40A

2Pack Enhanced 4S 40A 16.8V Li-ion Lithium Battery Protection Board PCB BMS Charger Protection Circuit Balance Charging Module for Drill Motor Motorcycle Battery (4S 40A)

Details

Description

Specifications

Common Questions