Pocket Hole Jig Woodworking Tool Kit Metal Pocket Hole Screw Jig System 3/8 Inch Accurate Adjustable Drill Guide Easy Clamping for Fast and Strong Joints

Fantastic tool! Makes pocket holes so quick and easy. I made a jig to hold it, the bits and the Allen wrench so it is always handy. The vacuum port removes ALL of the sawdust...no having to clear the bit halfway through each hole. The drill bit comes out clean after every hole. So worth the money!

I had a basic pocket hole jig before, but purchased this as an upgrade largely because of the dust port. That said, there are several other good features, in particular the scales built into the base, etc. that help with setup for differing thicknesses of stock. I built a base to hold it and accessories, including a small spacer the right thickness to support the edge of whatever you are preparing to drill flat on the bed of the jig. This makes it easy to clamp the jig on it's base to the workbench and when needed. The quality of the jig is good, however, one of the drill bits broke soon after I began using it (hence the 4 stars).

This pocket hole jig is fantastic. Had the kreg 320 and wanted upgrade. Was considering kreg k4 but this one was half the price. I have zero regrets with choice. This jig is sturdy and has a good weight. Huge improvement and so much easier and efficient. If you need a pocket hole jig you can't go wrong with this. I have recommended this to friends and wouldn't hesitate to buy this again. Another great product from Goingmake

The jig gets 5 stars. The drill bits, however, are another story. The tips broke off the drill bits the first time I used each one. Why even include them with the jig? Fortunately, I have a pocket hole drill bit from another brand, or I might have knocked off more than one star.

If you're looking for the best affordable pocket hole jig, buy this one. I previously owned 3 of the blue jigs, you know. the ones that rhyme with Keg. While they performed well, they always felt very overpriced for some injection molded plastic. This GOINGMAKE pocket hole jig is no joke. You are GOING-TO-MAKE with it! Some have complained that the bits are a little brittle and I could see that. Most Titanium Nitride( you know the cheap gold) bits I have used are sharp but brittle and do well for a bit but then break. I will say it survived my first failure where I didn't set the height of the gauge at first and plunged the bit into the aluminum base of the jig... Now I have a dimple in the jig to remind me. SET THE JIG... It worked beautifully in MDF, and in Hardwoods like my piece of cherry with very minimal tear out. I tested the worst of the worst cases, across grain, with the drill in the slow mode. On the left was fast, and right was slow, in this case, drill in the fast mode will produce better results as its a higher number of cuts pocket hole. Not to mention the jig is beautiful, the all metal construction, the ability to take it off of the hold down, and use it with standard clamps makes it incredibly versatile and easy to use, and the vacuum attachment is icing on the cake! If you buy this, be prepared to buy a good quality spare pocket hole bit if down time from a broken bit is a no go for you. Buy this over the blue brand. If I had one tip to the manufacturer, it's to place a detent(is that the correct word) or protrusion along pocket hole jig itself so when it rides in the slot it stays aligned better. Currently there an be some slop, although when you clamp down, that slop goes away.