Sikaflex-221 - Aluminum Gray - Multi-Purpose Polyurethane sealant/Adhesive - Creates Permanent Elastic Seal - Sandable/paintable - Non-Corrosive - 10.1 fl. Oz (Pack of 24)

I used Sikaflex to adhere a roof wing to the back windshield of my car, and I’m seriously impressed with how well it worked. The bond is incredibly strong and feels permanent once cured. I let it set for about 24 hours before driving, and even after months of highway speeds and temperature changes, the wing hasn’t budged at all. The application was pretty straightforward, it has a thick, tacky consistency that gives you enough working time to position everything correctly before it starts to set. I’d recommend taping or clamping the part in place while it cures, because it does take a while to fully harden. Once cured, it’s flexible enough to handle vibration and movement, which is great for automotive use. One thing to note: this stuff is messy. It’s sticky, and once it gets on your hands or paint, it’s not easy to remove. Wear gloves, mask off surrounding areas, and have some cleaner or mineral spirits ready. Overall, Sikaflex delivered exactly what I needed, a strong, weatherproof, and vibration resistant bond that’s holding my roof wing securely in place. It’s not the cheapest adhesive, but it’s worth it for the strength and reliability.

This stuff is fantastic, especially for bonding hard to glue plastics. Be sure to wear gloves - it is very durable on skin!

This sealant worked perfect on my Toyota Tacoma to fill the bed-line gaps. It is crack resistant I bought extra in case I ran out during the project but was able to get my money worth during the project. Dried quickly and looks like a factory finish.

This stuff works great for car windows. Make sure it’s not too cold because I did get a pinhole in one of my windows after I was struggling to get a perfect bead because it was so hard to squeeze the tube. Next time I will soak the tube in warm water for 20 minutes before starting to use it.(actually i will sous vide it to get it to the perfect temp and make sure I’m not overheating it)

Simple use, no surprises, requires a longer cure time before painting

I purchased this to seal mounting points for a Starlink antenna on top of our motorhome. This is a professional product and I expect it will prevent any water penetration.

What can I say that hasn’t been said? Used this to install a fan on a campervan. It ain’t going nowhere and 100% confidence it will never leak.

I had the rubber trim come out of it's groove around the windshield of my motorhome. As I was only a few miles from my dealer, I went directly there. The tech put Sikaflex-221 into the groove, pressed the seal back into that groove and used tape to hold it in place while the Sikaflex cured. I've had no more problems. So, I ordered two tubes "just in case". And, like insurance, I have them but hope I never have to use them.

Very good

Great brand always works

Excelente producto

Good quality

I needed some good adhesive to attach solar panels to my camper and a lot of places recommended this stuff so I decided to give it a shot. It applies just like any other adhesives, pretty straight forward, and when used as instructed it creates a very nice bond between two materials. I was wary at first driving down the highway on first test run paranoid the wind was going to rip them off, and after a couple summers with highway driving, I am now confident in the quality of the item. It does what it is intended for. Would, and have, bought this again.