VEVOR 3-Jaw Lathe Chuck, 6'' Self-Centering Lathe Chuck, 0.14-6.3 in/3.5-160 mm Clamping Range with T-key Fixing Screws Reversible Jaws, for Lathe 3D Printer Machining Center Milling Drilling Machine

This chuck is another fine product from Vevor. I purchased it to replace my older 6" 3 jaw chuck because I only had one set of jaws and was limited to holding my work pieces. The accuracy with the Vevor Chuck is good, and it is well built. This is probably the fourth chuck that I have purchased from Vevor, and all performed as expected.

Excellent runout been a machinist 45 year and was very surprised how good the runout was quality is very good

Used this to make a wheel polishing stand. Going to have to modify the chuck key to make it work for my application. All and all seems to be good for the price.

I am shocked how precise this chuck is. Once I mounted it on a LO backing plate, I am getting consistently less that .001" of runout, which is remarkable. I fully disassembled, cleaned, and lubed the chuck. The internal components appear to be well-machined and have very close tolerances. The only two jabs I could throw at it is that the back cover plate is made of plastic instead of steel and it applies friction to retain the scroll. You can't tighten it down fully because it will bind the scroll, so you have to leave the screws a little loose. I see this potentially wearing/loosening over time. Second is that the jaws are not numbered on the chuck itself. They are numbered on the "ways" of the jaws, but you have to completely remove the jaws in order to see the numbers. I purchased a CME 8" LO backing plate on Amazon and to my amazement it was a perfect fit for this chuck.

Idk what I expected for the price, but they did a bad job of finishing this chuck. It required a full disassembly and deburring and clean out of the box to run properly. And even once that was done, it typically only held concentricity as well as 5 thou most of the time. Other than that it functioned completely fine as a chuck. For the price I don't know if I could have expected any better.

Fine Chuck. As advertised. Good value run out within specs

Chuck was rusted badly inside and where jaws slide in body. No lube except where they wiped it off, oiled it, and bagged it. Every machined surface has burrs leftover from machining. VERY tight to turn and gritty, would seize up when adjusting jaws. Even cleaning would not correct due to excessive rust. Would wear extremely fast and uneven. Will return. Jaw height is also different from jaw to jaw.

Very solid chuck. Used for one week straight now. Spins true.

très bon mandrin, et à prix très correct

Bought lots of products from VEVOR and they are excellent quality for the right price. I just don't no how they do it. This 3 jaw 6" Self Centering lathe chuck is no exception. Quality made and smooth mechanism and great finish and accurate. I already have the 10" chuck / the 8" rotary table and many more and the quality is just the same so i've rated this 5 stars.

La cremagliera è scheggiata !

Se ve bien robusto y de calidad, por ahora me cumple perfectamente

Eccentricità pezzo dichiarata 0,05 mm rilevata con barra rettificata 0,5 mm, quindi inacettabile.Inoltre un morsetto chiude solo sulla parte anteriore. Reso subito, per fortuna acquistato su Amazon che mi ha rimborsato subito.