DIANN 4pcs All Metal Bimetal Heatbreak Copper Titanium TC4 Throat High Temperature for Creality 3D Printer CR10 Hotend

Tired of using a crappy plastic feed tube in your Elegoo 3 pro, plus, and Max printers? These parts are a must buy to upgrade your printer! No more plastic tubes that suddenly fail, forcing you to buy new replacement parts, saved my wallet!

Works fine for my neptune 3 pro

No clogs for pls Pete and and since using with cht nozzle on enter 3 neo.

Heatbreak is about 1mm longer than it needs to be for the Neptune 3 Pro but it definitely works with the stock PEI sheet. Could not be happier with the results!

Great

This product lifespan is a little less then the assembly time. The two pieces will not stay together long enough to print a half hour job and you find your filament drip down over your hotend istead of through it.

Title says it all. These were bent, and poorly finished at the bottom edge. I found 1 that was bent, and 3 that looked good. I installed 1 of the 3 only to find that the nozzle couldn't correctly interface with this heat break which caused a massive leak that you wont find until it is too late. I would buy Polisi3d heat breaks instead. Buy once, cry once.