PAUTIX 12mm 3-Pin Connectors for RGB Smart IC COB LED Strip Lights,Solderless Terminal Connection Kit,Dual-End Extension,Strip to Male Plug,Gapless,Strip to Wire Connectors,24V 12V 5V LED Light Strips

Easy to use

Purchased Pautix RGB Smart IC COB LED Strip Lights and needed to cut the strips for use in different areas. Bought the cable along with 12mm connectors, lots of options for connecting. Cable was easy to use, flexible and seems to be durable along with the connectors. Just be careful to cut the COB LED lights at the designated locations straight. Wasn't 100% sure how everything worked until I received all the items and it was a breeze to set up and install. I suggest to take the time to lay everything out first and think how the connectors are used (I saw a lot of people had problems with connectors couldn't be used the direction they wanted, I had no issues). The adhesive on the back of the COB LED Strip lights work well, just be sure to clean the area you would like to mount to. Very pleased how the project turned out and now thinking of purchasing more COB LED Lights for other areas.

Just dont strip wire it bites through

Cutting my LED strip and connecting with one of the corner connectors was simple to do. Unfortunately, all of the connectors are angled the same way. They are not reversible. The direction in the pack I received was opposite what was shown in the photos. I’m using the LEDs for under cabinet lighting. My cabinets only angle one way. Unfortunately, this packet of corner connectors was not going to meet my need and I returned it.

This kit makes it easy to repair the connection between your controller and the strip. Just line up the strip and connector slot and crimp down the with just regular pliers. pretty Easy.

Great quality, a good product, and it's very easy to install.

They connect fine, are proper size and had no issues there. If you have these connectors anywhere they could get bumped (dusting or similar), they will not maintain solid connection. There is no way to replace. I thought the teeth may hold better, but they don't. If you have to service any part of tape (I had a bad led), these are useless. You will have to cut back to next cut point to use new connector. You cannot assemble anything on the floor to test, and then install your strips. The connectors are not long/deep enough to stabilize each piece, so the tape will slightly shift and the teeth of the connector will move and make the connections fail. These are better than the spring style connectors, but still not great. Soldier is still the only dependable way to connect pieces.

Box knife and pliers and a couple brain cells are all you need. Took a sec to look it over and see what needed to be done, but that took maybe 20 seconds. Every connection went together quickly and easily and worked first time. Careful not to oversqueeze the connection or risk cutting right thru the led pcb. My application was outdoors, so I added 1/2“ 4:1 clear adhesive shrink tubing over the joints.

Worked perfectly, no soldering or tools needed.

Lo compre para tira led cob gliztech y los conectores no quedaron.....