Flosse Druckstange Se Sport 400 Mas 40 CV

Purchased for a Worldcat 255DC with 150 Yamahas. These are easy to install at the sandbar using the supplied hardware, a 7/16" wrench and Phillips screwdriver. I was able to baseline the boats performance prior to installation, but I have not re-evaluated post installation data yet. These were installed when the boat was at full fuel, and an excess of gear and people aboard. One thing I can say for sure though is that it has gotten the boats tendency to porpoise under control, which was the main reason I wanted to install them. They work. Up on plane at lower RPMs and definitely a smoother ride and less fiddling with the trim control. I've been checking the torque on the nuts and have re-tightened a couple times. I will drill through mount these soon since they are of noticeable benefit.

Colocado en cola Alpha One II con un resultado extraordinario. 100% recomendable

I havnt owned it very long but I went with the drill mount method and it took about 30 min start to finish. I personally love the way it looks. It feels sturdy so I dont have concerns that it is going to fall off. It's on a 16' bayliner capri with a 90hp outboard 2 stroke motor with a 13" propeller with a 19deg pitch Loaded down with 3 adults and camping gear it still takes a bit to get up to speed but thats just because the motor is on the small side other then that it feels great and solid while up on the plane. If it's just me in the boat it pops out of the water, feels rock solid and I have certainly gained a high top speed. For the price I totally recomend and I plan on buying the se200 to try on my tin boat with a 9.9hp

IMPECCABLE

Great performance but I had to cut a small piece to fit my 50hp honda