Radiant Barrier RadiantGUARD Ultima FOIL Insulation Roll 500 sq ft | 48-inch by 125-feet | U-500-B | Heavy Duty Perforated Foil Radiant Barrier Attic Insulation - Blocks 97% of Heat

Exceptional product, can't tear it, you have to cut it. 97% heat reflectivity! Installed this everywhere in our RV. Ceiling, walls, floor and it has cut the inside temperature down dramatically. One thin layer does the job. I am ecstatic that I took the chance and purchased this product. It is easy to install: measure, cut and install. Purchase this product if you want your RV to stay cooler, you won't be sorry.

I can make several comments. It is easy to install. You can cut panels and if too short, or a hole (uneven roof) you can just tape over with metallic insulation tape and you don't notice. It reflects light really well and it definitely insulates the attic in winter from drafts and cold. When lights are on, the room warms up.We have not had this on long enough to assess its radiant barrier insulation benefits; that likely can not happen until July here in the far northeast (we still are freezing in NY).What was important to us was insulation against the old attic insulation making it safe to manouver without exposure to that stuff; ease of insertion, and it really does provide insulation against the cold. We have had only 1 60 degree day and the insulation did not get overly warm. I hope to have an opportunity to update this once summer comes.

This is really nice stuff. It's actually a lot cheaper at HD but it's not stocked and delivery is slower so I paid extra to get it quicker from Amazon.It's very tough and thick and does not tear but will cut easily.I would highly recommend getting a $20 pneumatic stapler from Harbor Freight to install. Of course you will need a compressor for this but it's worth it. I used around 2000 staples for a 1200 sq ft attic.After install this really made a difference in my attic heat. Well worth it.

This foil is good enough for light duty. It is easy to put up, easy to trim, and fairly strong. We used it as one layer in a three layer application of insulations. The results are good enough that I would add this product into any insulation installation that does not need to breath.

This review is way over due. Infact 4 months overdue. I am so impressed with the performance of the radiant guard I purchase and installed under my rafters inside my attic. It literally dropped my attic temperature over 20 degrees. For instant, I live in south texas and my current air temperature outside right now is 95 degrees. My attic temperature is an incredible 99 degrees. I installed this in June and immediately notice my upstairs bedrooms much cooler. Also my old air conditioner was now kicking off for the first time once the upstairs thermostats reach their programed temperature of 78 degrees. Before, they would literally run all day non stop. Last August 2015, my electric bill I paid $281 This current August will was $242, That's a almost 40 dollar savings. I figure the radient guard will pay for it self in one year. Not Bad!Thanks RadiantGuard. Outstanding product and most highly recommended

The roll was shipped and delivered in 2 days and was torn open by the shipper, but the product was OK so we kept it. The foil was used to retrofit a vaulted ceiling that wasn't insulated or vented properly by the builder. The foil was very easy to work with and having to to this after the fact was hard enough to deal with and this product made life so much easier. We used it to wrap around 3/4" foam sheeting and then used more foam on the top side to create air space between the foil wrapped foam boards and the bottom of the roof deck. This was needed to create the air space from the eave to the ridge for proper venting and the needed air space for the barrier to perform correctly. We insulated behind that with R-25 fiberglass insulation. The foil barrier alone before the insulation was installed created a better comfort level than the entire area was before the retrofit and now with the insulation and the drywall installed it is a completely different area. I can't wait to order more to do our attic area...

We purchased a barn style storage shed with a loft and a metal roof. We placed the Radiant Guard over the 2x4's that frame the roof on the inside which left an approximate space of 3 1/2" of air space between the Radian Guard and the roofing material. This was very effective at blocking the heat coming through the roof and probably lowered the temp in the shed about 20 degrees. I was very impressed! It's also fairly easy to work with and is relatively strong and doesn't rip easily but can easily be cut with scissors.