EXLATEX Latex Hood Mask Rubber Catsuit Pinholes for Mouth Eyes and Nose with Zipper Latex Mask

its ok

Terrible item, not the same as item shown in pictures

Regardless of the holes, it's so hard to breathe, sure it's tight ass latex on your head, but it's still very complex to breathe (and see). Maybe make one with a gaping hole at the front so it can also be used for other uses yk?

The hood is absolutely huge! I ordered the XL as that was the correct size for my forehead measurements, however the rest of the hood was way too large and not in proportion. This caused issues with the excess material acting like a breath control hood! The pin holes were poorly done also. On the inside of the hood, the latex where the holes were punched was still attached on half of them. The zipper at the back wad very stiff and hard to operate. Latex kept getting caught in the zipper also! I'm attempting to return the item due to its poor sizing and construction.

Holes are not even, they are different sizes on the 2 sides of the face

Se eompio a la 3era puesta

The picture is for an entirely different product. This hood is not microperforated or well fitting. The holes are large, obvious, and misplaced. Don't even bother trying.

I got this a few days earlier than they said it would get here. It is good had heavy material and the fit is good. The front of the neck could be a bit longer and the pin holes for the eyes, nose and mouth could be just a bit larger. Other than that is is just what I wanted and at a very good price. I shined it up and it shines very well. I am a large man and this is the first latex I was able to but in a off the shelf size and it fit me. I have to have anything I wear custom made to fit.

The listing "With Zipper" is incorrect. The product arrived without zipper and was too small. (I ordered medium head size - as I always do - and they sent what is a small size.) Product arrived in an unmarked package with no size shown, so typical for Amazon purchases, isn't it ? It says latex but looks, feels and smells like the cheap rubber used on bicycle inner tubes. Low quality product.

Thought I would take a chance despite the other reviews in hopes that maybe they just had a bad batch, or they actually fixed the issue. No such luck. Similar to what others have said, I'm not sure what sort of creature this mask was designed for, but it wasn't humans. The primary issue is that the nose contour is much too low. Basically, if you put it on so the chin contour is on your chin, the nose contour lines up with your mouth, and the eyes end up by your nose. I measured the distance from my chin to my nose and it is about 8cm. The distance from the chin to the nose on the mask is about 3cm. We're talking close to 2 inches too short in US measurements. Shame because other than that, the latex seems pretty decent with the .6mm thickness on the no-zipper model. I think it would probably hold up pretty well. The price is good for a dipped mask like this too - half of what most cost. Too bad the person that created the form didn't bother to try it on an actual human before starting the production run. Oh, and even if it was anatomically correct, it still wouldn't look like the pictures - those have a much longer neck that fits tighter. This one is pretty short and kind of loose. It would be livable if the face was ok, but instead adds one more thing that is misleading. It's going back. Bottom line: don't bother.