Cardone 66-4225 CV Drive Axle Drive Shaft Automotive Replacement Compatible with Honda Odyssey 2005-2010, Honda Ridgeline 2006-2014 Model Years

CV axle fit perfectly no issue . Eliminate the vibration issue I have on my Honda odyssey .

LJ's swapped em out for me. I tried, but didn't have the right tools and free time. Both axles at 165k. Axles must be due to swap out at about 150k I now know

Had them for a year now and still working great, boots are fine even with a harsh winter and lots of potholes. They are rusting a bit but it was much cheaper then OEM Honda shafts. Watched several you tubes to remove them, some people do not do it correctly but gives you an idea on how to do it. Passenger side was a bear, but the Youtube with the guy who uses a small 18-24" crowbar and uses a bolthead as a fulcrum point is the easiest way to remove it from the passenger side. It took me all day to do both sides with changing the stabiler links, rebuilding the top strut mount and an oil change while I was down there. Also removing the Strut bolts were much easier for me. No alignment needed, I marked the location and angle of all the removed bolts and nuts.

I was able to install it easily. HOWEVER, the tolerance is not tight enough to mate with Honda inner shaft, so it created vibration while driving. My inner shaft is OEM from Honda, so their engineers need to measure the tolerance again and make sure it mates with Honda's shaft tightly.

Works great. However, not an "exact" match to oem. It has a dust metal shield that caused concern at first, but was fine in the long run.

Exact replacement for 2006 Honda Odyssey Drive Axle Shaft. The installation was quite easy and straight forward. The price is right. No noise while test drive the car.

Bought this for our 2010 Honda Odyssey EX-L with approximately 158,000 miles. It developed a slight vibration in the front end at speeds above 40mph. After replacing the Front brake rotors and pads as well as having the wheels and tires road force balanced, the shimmy was still there. Bought and installed the CV axles after researching the issue on the Odyssey forums. Install was pretty easy and even though the original parts looked ok on the outside (boots were intact), these cured the shaking completely. These are much cheaper than the Honda OEM, which I was going to buy initially. In my case, this axle worked well.

The first set (also purchased here) lasted for about 60,000 miles before I started experiencing some steering wheel vibration. However, they probably would have lasted longer if my engine wasn't shaking a lot because of bad motor mounts - the next thing I'm replacing.