E-Z Slide Boat Trailer Slides and Bunkenders for 4” bunks – in Black or White

They were a great addition to my trailers bunks . Very quick & easy to install. I just launched my boat at the ramp & parked the truck & trailer. I’d brought a tape measure & a driver & drill with me. In a matter of minutes it was done. The boat winches much easier & those side to side adjustments are much easier because of the plastic glides.

I finally had a chance to put these on my boat. They worked great. I have a 20 foot aluminum boat with 4 running boards . I bought 2 sets. Time will tell if they last long .Warning , don’t unhook the bow until the boat is close to the water. The boat slides off very nicely .

The lake I launch from can be shallow at times which makes it difficult to launch without getting my rear tires too far into the water. My bunks are covered in plastic vs. carpet but it was tacky not slippery. I have a pontoon so I ordered 2 sets of slide pads. Easy to install, says not to use a power driver as you may crack it but using a 1/8" drill bit to predrill made it it very tough to screw in by hand. So I lowered the torque setting on my Bosch Driver and no problem. If you do not want to, use a larger bit to pre-drill

These pads definitely made the difference. 100 times easier to get the boat off and on. Be care putting the screws in. The head of the screws will strip out very easily. They are Phillips head but the stainless is very easy to screw-up. But I would recommend them.

These are a lifesaver. There are many boat ramps that I have not been able to launch from due to low water. Now I can shove my boat off or load it with ease regardless of water level. If you are a jet boater looking to launch at shallow boat ramps but don't want to invest in roller bunks, GET THESE. I have tried some of the cheaper knock offs available on amazon and though they look the same the knock offs lack the slickness that these have.

Easy to install and they work like a charm... just be sure your bow is secure when the boat is on the ramp or it might slide off the trailer. (The voice of experience!)

Purchased to cut down on labor on electric motor lakes. It always a challenge pull boat onto trailer whenI can't use the gas motor pull up onto trailer. This made the pulling up much easier. The screws are stainless screws. Most marine screws are soft metal. ** ->So drill the correct size pilot hole!

Holly Molly ,,,,,, the E-Z Trailer Ironwood Slides work great !!!!! If you have trouble with unloading your boat because of a short trailer tongue , trailer sits too high or you just don't want to back up into the water too far. These slide will definitely make sure your boat gets off your trailer quick...… USE CAUTION ONCE YOU UNHOOK THE BOAT GRAVITY WILL KICK YOUR BOAT OFF INSTANTLY... BUY IT AND DON'T WORRY YOU WON'T REGRET IT BEST UPGRADE I ADDED.