Paasche Airbrush 10-Foot Nylon Braided Air Hose

Needed a new hose for my "old" Paasche H0910. Connector was bent and it was leaking more air than what came out of the airbrush. This is a PERFECT replacement and now I can get back to my artwork. LET'S GO!

Somewhere along the way, after a 10 year hiatus from modeling, I lost the original air hose for my 50+ year old Binks Wren airbrush. The hoses readily available didn't fit but this one worked great.

This hide and moisture trap solved my airbrush moisture problems! I have a filter/moisture trap on my air compressor but my airbrush still spit water during long pairing sessions or when it was humid. The trap on the compressor was too close to the source; the moisture was condensing in the hose between the trap and airbrush. The trap in this hose captures the moisture before it gets to the nozzle. A periodic partial loosening of the screw on the side of the trap allows visible droplets to escape. Problem solved. Note that I was concerned about the length of the hose but it turned out to be a benefit. My compressor sits on the floor of my basement and I ran the hose up to a screw hook in a first floor joist and back down again. It’s actually easier to maneuver the hose in that position than when my prior hose rise off the floor. With quick release fittings on my airbrushes I feel I have a much-improved setup. Definitely recommended!

My cordless compressor is a little loud so Ieave it outside and run the hose inside at 30-40psi with no issues.

O was having issues getting an in line moisture trap for my paasche airbrush. i decided to try the paasche branded in line hose. It works great however pay attention to the length . i was shocked that the hose was 15 feet. Im sure i'll be glad i have the extra length later but i do wish there were shorter options here

The quality of the house is great. I will, however, need to buy adapters to make it fit as the listing was confusing about connector sizes. One side is too large and the other is too small.

Bought this Air hose with Moisture trap after having my regular hose blowing out moisture. So far this has been worth every penny since I have not had to do any rework. The only problem I have found was the valve stem screw came loose and fell out and we could not locate it anywhere. I fixed this by putting a cup hook in its place which worked out great. If these were a bit more reasonable I would buy more but until then I will keep working with this one.

This is air hose to get if you have a Passche Airbrush and do not want to mess around with adaptors. The fitting that attaches the hose to the air brush itself is a different size compared to most other air brushes. The hose is flexible, lightweight and easy to manage. It appears to be well built, but time will tell if it lasts.