Carmyra Portable Chainsaw Mill 36 Inches 304 stainless steel and Aluminum Planking Milling Bar Size 14 Inches to 36 Inches

Bueno, sólo tardo mucho en llegar

He tenido que sustituir dos tornillos de origen ya que se desafían al apretar, pero en general bien

I bought this mill to make lumber for wood shop projects. The local store doesn’t sell slabs of sufficient thickness for what I want to do so I wanted to make my own. This mill does the job perfectly. I have it mounted to my Stihl 461 with a 32” bar. I bought a ripping chain for milling and highly recommended that you do so as well. A standard chain should have a cutter angle of around 30° where the ripping chain has a cutter angle of only 10°. It is also sharpened with a special flat/angled file instead of a round file. It is made for milling and should not be used for general cutting. There are no step by step instructions for assembly, but it comes with a schematic that shows how to put it together. It took me about half an hour. Mounting it on the saw is pretty strait forward. Just make sure you clamp it where the sprocket/tip meets the bar, not on the sprocket rivets. Doing so will compress the tip and not allow the sprocket in the tip to spin freely, ruining your bar which can get expensive. I get about 25" of useable bar with the 32" bar. I could probably get another inch if I were to take the dogs off the powerhead but that’s a lot of work for minimal benefit. When milling, go slow and make sure you support the slab with wedges or shims to keep the weight of the slab off the bar. Let the saw do the work and don’t rush it. For the first cut, I made a rail out of some 1x4 and scrap 2x4 pieces. I secure this to the log with screws on the bigger end first and measure to my intended line which I draw with a level on the log end. On the smaller end I shim up the rail to a similar line the opposite log end. I then set the mill for that thickness and make my first cut. For subsequent cuts the mill rests right on the previous cut without the rail. There are videos on YouTube showing how this works. Overall, I am happy with this little mill. It makes accurate cuts of any thickness. I was surprised at the weight. It is very light and easy to use. If you’re wanting to mill your own lumber I highly recommend this mill.

Les serres en U ont brisé après seulement 1h d’utilisation. J’aimerais avoir un remboursement

Assembled it last night and will try to put in use sometime this week depending on my schedule. It appears to be built well and will last for a long time. I hope to be able to use for a long time.