Attachment 27F6 35K3 73H5 94Y2 Liftoff Cleaner Hose

المناج غير ذو فائده لم يركب ع الغساله

Bien, la instalé en pocos minutos, siento que es más flexible y quedó bien, hasta ahora después de dos usos funciona

The hose on my Bissell SpotClean wet vac developed a hole, so it did not work well anymore. This replacement hose was easy to install after watching a video on YouTube, and has worked great.

Perfect fit replacement hose for the Bissell SpotClean Pro I have. It's a shame that Bissell refuses to sell this part or even list it's part number on their website, instead directing you to an "authorized service center". Having done the replacement myself, it's not the easiest job in the world, but for someone with a phillips screwdriver and a pair of needle-nose pliers it's not terribly difficult. For those who are interested, here's the procedure: 1. Detach both the solution tank and the waste tanks from the unit. 2. Remove the six screws that hold the outer shell to the unit. Two are at the bottom of each side and one at the very top of the arc. 3. Remove the three screws that are on the cord wrap assembly. Two are in holes in the wrap arm and one is under where the solution tank sits. 4. On the hose wrap, you should be able to feel a spot at the bottom of the round grey sticker on the side where there is a void behind. Carefully push a flathead screwdriver into this, and pull back to gain leverage to remove the sticker. Peel slowly with even pressure to avoid damaging it. 5. Now remove the five screws that hold the hose wrap to the side casing. At this point the hose wrap and the outer shell can be completely removed. 6. Between the two chimney-shaped tubes that feed the waste tank, there are two screws attaching them to the motor housing assembly. Remove these next. 7. Now remove the four screws that hold the lid of the motor housing onto the body. Two are in deep pits toward the outside of the unit and the other two are exposed toward the middle. I had to use a right-angle screwdriver to do the middle ones since they are underneath an overhang, but it may be possible to remove them carefully at an angle with a bigger screwdriver. 8. Lift the cover off of the motor housing and use needle nose pliers to loosen the two hose clamps that attach the T-shaped connector. 9. Attach the new hose's T-shaped connector and put the hose clamps back into place. 10. Make sure the rubber gasket around the solution hose lines up with the notch in the motor housing, then reattach the lid and screws. 11. Reattach the two chimney screws. 12. Reattach the outer shell pieces, making sure all the tabs that lock them together are correctly aligned, then reattach the six outer shell casing screws you removed in step two. 13. Reattach the three cord wrap screws. 14. And finally, reattach the hose wrap and it's five screws, then reattach the round grey sticker.

After a good 10 years of use, the hose on our liftoff unit split, and the end that holds the wand cracked. I picked up this hose and it fits and works perfectly. Recommend that you watch the Youtube videos on how to do this. Very simple to do, but the videos are helpful.