Shark Industrial 15 FT Stainless Steel Braided Ice Maker Hose with 1/4" Comp by 1/4" Comp Connection

bought to connect my high-pressure city water to an RODI system that recycles brine till ideally concentrated to be wasted handles the 75-80psi with gusto and doesn't bat an eye and yes, the city water is 75psi average, no regulator in this old building

Great quality.

Easy to install and appears to be good quality. Slight aftertaste in water as you woukd expect but not noticeable at all in a smoothie.

I had a old copper tube for the refrigerator water supply that sprung a leak after 20 years. It was also kinked in a couple of places from when the plumber installed it many years ago. This hose is way better. It was super easy to run and won't kink. The only issue I had was that the fittings on this hose are somewhat larger than that on the old copper tube so I had to enlarge the hole in the floor where the tube ran into the basement to connect to the water supply line. That took a couple of minutes with something like a half-inch drill bit. Make sure you get a long enough hose. Measure the distance from the fridge to the supply pipe carefully and then add in a few feet to account for pulling the fridge away from the wall for installing the hose and later service. I would err on the side of something too long over one too short. You can always loop it up and hang on the back of the fridge or the wall if you have some extra length.

I AM USEING IT TO CONNECT ICE MACHINE IN REFRIGERATOR. I DID NOT GET TO IT YET BUT IT SEEMS VERY GOOD .ONE VERY GOOD THING IS YOU CAN ORDER THE LENGHT YOU NEED NOT SO WITH COPPER MOST OF THE ROLLS ARE 45 OR 60 FEET THAT MEANS A LOT OF WASTE OF COPPER . IF I WAS STILL WORKING AS A PLUMBER THERE WOULD BE VERY LITTLE WASTE.. THANK YOU ED FEELEY