Motorcycle Seat Gel Pad Car Driver Passenger Seat Cushion Shock Absorption Mats Soft Cooling DIY Gel Pad Comfort Long Sitting Office Chair Wheelchair Seat Cushion Orange (25 x 25 x 2cm)

This product is not designed for hi-fi audio use, but it works very well as an anti-vibration platform for heavier electronics (use Moongel for lighter electronics). I use it for my Gustard R26 DAC and for my Linear Power Supplies, one of which powers my Singer SU-6 DDC which has an OXCO clock that is sensitive to vibrations transmitted through cables, etc. (SU-6 itself is too light for this pad to offer meaningful vibration protection, and so is on a Moongel platform). The legs on my electronics are lifting the units off the pads and offer better vibration response as the weight of the electronics is suspended in the gel through the legs rather than the entire base of the electronic device.I suspect this will work well as a cheap anti-vibration platform for turntables. Compared to typical anti-vibration legs that are usually only good for 2 dimensions, this feels like it will offer anti-vibration assistance in all directions as long as you let it suspend on the gel through legs of the electronics.The fact that this unit can absorb heat based on other units is a plus for hi-fi electronics.This pad is super sticky after peeling away the plastic and so I rubbed it with corn starch and dusted it off thoroughly to get rid of the stickiness. It has been easy to handle it since.

Work very well.

Super simple to install and can ride longer between stops.The downside is it absorbs the sun like a sponge.It took at least 30 mins for it to be bearable, but by that time, I was already burnt on my butt.Going to take seat cover off and add a piece of fabric, or carry a towel wherever we go, to keep both seats out of direct sunlight.

Product is extremely sticky. I returned to sender.

Installed the 2cm gell pad in my motorcycle seat . The seat is now very uncomfortable. 1cm might have been a better choice?

Took about 4 hours to complete the installation of the gel pad. About 30 dollars for spray adhesive and new razor blade. If you seat area is concave like mine cut the hole smaller then the gel. I laid it on the seat and just traced ended up with a whole that was almost a half inch longer because of the curve.Using the seat for a week now. The pains I was getting from the seat originally are gone and seat has a good firmness to it. I fell a lot less of the road vibration compared to before.

Got what I paid for

Product showed.. Plastic completely stuck to it.. But it's here...