10 Pieces Extended Stainless Steel Wire Steel Cleaning End Brushes Pen Wire Brush Rust Paint Removal Bits Polishing Rotary Tools Accessories 3 mm Mandrel (6 mm end Brush)

Fit my dremel tool and held the bristles

For years I struggled to get the carbon off of the inside of the BCG. Regular Dremel bits were too short. Drill bits were too large. I had to resort to wraping steel wool around a rod and soaking it with Hoppes. It took way too long to get it clean. These bits are perfect. Use on low speed, not high as they will tear themselves apart at max speed. Gently inserted until they hit bottom and in seconds the carbon is gone w/o damage to the chrome lining.

One use tool. Do the job in hard spaces but don expect much service

I bought these to clean up the fuel injector bores on an intake manifold, absolutely perfect! They fit in a Dremel collet & are a lot more sturdy than I thought they would be. Perfect for this application, also for cleaning up the manifold as well.

They’re good but i thought they’d be more rough!

Decent dremel reach _after_ shortening shank by 25-30mm. At full length, you'd better use a drill on slow speed. In a dremel, even at lowest speed, it'll bend and slam into your face shield--which you're wearing, right? After learning the hard way, cut the shank above the bend, and the brush is suddenly useful. Even then, the reach is much better than any in-store brush. The bristles are much finer and shorter-lived than a big wire wheel, so you'll go through a few of them even for a small patch. At least you can reach it now.

Awesome quality tool can be used for home, shop and sports maintenance. Thanks

Was really happy, used to clean out the abs tone rings after pulling out the abs sensors of my old rusty truck, worked great and didn't loose any brushes inside the hub that I could tell and cleaned off the rust. However remember these brushes aren't mentioned to last a life time and need replacing after heavy use but 2 brushes cleaned the rings considerably since I had the truck on Jack's and drove it while using these to clean.

Would not attach them to a drill.

Work very well