KUAFU Motorcycle Storage Box Tail Trunk Luggage with Top Rack and Backrest- Classic Black

Looks great, decent size, mounting was moderately easy to accomplish, very sturdy not cheaply made of course lights don't come with it. over all I'm very pleased and will buy another very soon.

I installed this on my 1999 Harley Davidson Heritage Softail. I am an experienced DIY'er. I had to remove the sissy bar from the factory rack . The case will not fit or open if there is a sissy bar on your rack Removal of mine was a royal PIA.There are no installation instructions included so you will have to wing it. The pre-drilled holes at the bottom of the case did not line up properly with my rack so I had to drill holes to mount it. There are no pre-drilled holes for the chrome rack to mount on top of the lid. Under the lid are indications where to drill the holes. Once drilled the holes did not line up exactly with the feet on the chrome rack. I had to "stretch" the holes but that worked. On my first ride the lid rattled and came unlocked. On inspection I found that the rubber cushions attached to the inside edges of the lid were installed incorrectly. I re-installed them with glue to prevent them falling off. It solved the rattle problem. Overall this is an acceptable product as to design and construction. It is light weight. It is reasonably priced. Four stars.

Good box for the money. Holes for the metal rack isn't predrilled might give you the option for rack or no rack. The lock looks cheap but it is from China. Didn't much care for the gloss black but I planned on painting it to match. Also the luggage rack on the sissy bar needs to be wider than the 8 1/2 inch shown in the picture. There's no instructions either but with a little know how it's easy to mount. Also roomy. It fits 2 full size helmets or a typical gym bag with clothes and essentials. Not sure how water tight it is but it does rattle a bit. Might be from the fact there's no seal around the bottom half where the lid closes.

We are very pleased with the storage capacity and ease of installation. We would order this again.

The backrest has a lot more padding at the top than at the bottom, which pushes against the rider's back uncomfortably if the rider leans back against it. To correct this, I went to the hardware store and got some new hardware bits to create a spacer between the front of the trunk that changed the backrest angle (and then I filled in the gap I'd created with expanding foam, which isn't visible unless the trunk is open. Other than this, the trunk itself seems pretty good. It holds a decent amount and it feels solid enough. (Update: I've made a few trips carrying gear in it, and it has performed well. The overall amount it can hold is good, and it's sturdy enough.) My solution to the backrest angle is in the photo - I went to the hardware store and bought assorted metric couplers, bolts, nuts, washers, etc. I've got the backrest mounted to the trunklid so the lower part of it extends much further out than the hardware that came with it allowed. This gives the passenger a much more pleasant angle when they lean back against it. I used big washers on both the inside and outside of the trunk to (hopefully) prevent it from cracking or pulling a bolt through, and everything feels super solid.

Works for what I need it for. better then paying 1400 dollars for an Indian one. And I only use it two or three times a year

Not an easy mount but with some imagination you can make it work and the final result is good.

No mount.. no holes drilled for the rack or mount... holes for seat don't line up... flimsy plastic.... hinge broke.... no key... nuts and bolts missing.... lights had no bulbs...... most important part for me is the helmet didn't even fit. Worst product I've purchased on Amazon yet. Spent 8hrs reinforcing and fabricating this hunk of ####. Thanks allot