RC2124 3/4-Inch by 12-Inch SDS Plus Carbide Rebar Cutter for Drilling with Rotary Hammers, Gray

Trying to install my 2 post lift, I ran into a piece of rebar directly in the way of one of the mounting holes. After fighting with other bits for a while, I decided to just buy this thing. Worth it, this thing cut through the rebar in about 10 seconds. No problems.

After fighting to cut thru 1/2 inch rebar with the Diablo brand concrete/rebar 3/4 cutter, I purchased the Bosch 3/4 rebar cutter bit as a last resort. After about 30 seconds the bit successfully cut thru the rebar and allowed me to finish my job. Used with a Makita rotary hammer drill set on drill mode only! Thank you Bosch for a great product! Highly recommended!

Excelente drill bit !Got me out of a real crunch ! Item worked great !

Great for destroying rebar in coring holes

Cuts thru rebar with ease but make sure that you change your settings on your rotary hammer from hammer to drill when you change out bits. If you don't, the cutting teeth will wear out quickly. A SDS + bit that you will need when drilling holes in 12" thick concrete walls reinforced with rebar. Great price on the new Bosch bit.

The description says it all. Good quality.

I was drilling 12-inch concrete block walls, and 10-inch steel reinforced concrete walls using Bosch HC2167 1-inch bit and it worked fine. I was expecting to run into steel rebars eventually so also purchased this Bosch RC2164 1-inch "rebar cutter" bit. On the first rebar I ran into I switched to this "rebar cutter" bit. It was a total disappointment. Lost a couple of the carbide tips in only a few seconds and not made a dent in the rebar. Shortly after all carbide tips were gone and the bit mushroomed.

I purchased it because i hit a rebar while drilling through my foundation.. thought it will cut through rebar but after 20 min of drilling in rotary mode using my dewalt rotary hammer drill as instructed, it had not moved an inch. returned it for a full refund.