AB Tools Thin Two jaw Bearing Puller/Remover 30mm - 90mm

Seems well made and sturdy, alot better than I thought it would be for the price. I've been in the trade 25 years and would say its almost professional quality.. used it to pull off the kicker gear on old harley 4 speed gearbox, done it with ease and no signs of damage or wear to the puller, will be in my toolbox to use time and time again. If you are in need of a puller, this will do the job and probably alot more after. Worth the money.

I used this to get the nuts off the wiper motor spindle as part of replacing a front shock. It worked well and stood the task. It is thin and two jaws so ideal for that sort of job.

This is a really good compact puller with very thin jaws that can get behind a bearing in tight spots. It is let down by the spindle which is about 15mm too short. I had to pack out the spindle to fully remove the bearings

I bought this with one specific job in mind: removing some 42mm bearings from unicycle hubs. It arrived promptly. Did the job easily. It took 30 seconds if that to remove each bearing. You need a spanner/wrench to operate it. 2 sizes if you choose to lock the jaws into position. I found that the jaws simply held in place once they were under slight load and that made the job quicker the second time round. A professional would have a set of more specialised bearing pullers, but this is fine for those of us who only need to do the job from time to time.

Quite heavy and chunkier than expected. Casting and finish just a little rough but it's not an expensive item and it did the job it was purchased for. OK for occasional use. No ball bearing tip as advertised which is a bit naughty.

Sturdy little puller that worked a treat, easy to use, removing chainring spider on an ebike. Would recommend 👍

I bought this to remove a gear from a lay shaft in my mini gearbox as my current pullers wouldn’t fit under the gear. These are small and fit underneath and removed it no problem. So I know I’ve only used it once but five stars as it did the job I bought it for.

The jaws have little to no grip and will just slide out of position. The bolts at the top of the jaws that hold them on the top rail are useless. This results in the jaws falling out of alignment and slipping (as above) The thread on the central bolt that winds the tool started to fur up and get tight; likely to strip . It couldn't manage the job, so returned; however the time wasted on this useless junk I will never get back. AVOID!

Netjes en snel geleverd helemaal top

Good quality

Fungerade över förväntan. Jag använde den enligt bild på en Toyota 4A-GE motor.

This was the best solution to remove a circulating fan in a small commercial convection oven. Very limited space to work and this tool was the answer. Sturdy and undoubtedly will get more use.

Ho comprato due estrattori per un lavoro particolarmente ostico, questo è il più costoso ma anche il più valido. il prezzo è giustificato dalle caratteristiche costruttive, non ho risolto il problema perchè gli artigli dovrebbero essere ancora più sottili ma l'utensile lo tengo senza dubbio per ampliare la mia gamma di attrezzi. Acquisto OK