MT50

I purchased this cable to interface between the EPEVER 10A MPPT Solar Charge Controller and the PC . The Solar Guardian PC Software is free on EPEVER.com and it make programming and monitoring very easy. It works very well with no lag in data transfer.

This unit will drop connection and requires a mechanical reset, meaning you have to unplug unit and replug it to start wi-fi again. So, if you aren't home and it goes offline then you're out of luck. I have ruled out poor wifi signal as I have other devices further away that do not drop. I have utilized an extension in the hookup and have reduced drops to about 1 or 2 a week. Not bad now. The app provides useful information from my solar array.

For the life of me i through this was WIFI. Once i corrected my thinking it works fine. The app can show you what is going on, but the app still needs more controls, Lay out work, ...

Simple plug and play installation, but it doesn't seem to work properly and reads a constant -14 degrees F when it's actually about 40 degrees F. I tried to reset the controller unit, unplugged panels and battery power several times, unplugged and re installed temperature probe and it goes back to -14. At least it was inexpensive, but not worth the hassle to send back...

I had MPPT inverter for over a year and multiple attempts use arrest for 85 port connection and my computer to program. It was very painful, never really succeeded. Always trouble through the windows to find the correct driver. Then the software never really dumped the programming into it and I give up. Then almost a year later after that event I decided you know. Let's give it a try. This little remote console I say red that it should be able to program my inverter to charge my lithium battery properly. Guess what? It took me 10 minutes to set everything up. The word of advice in my setup. I do have a full access to my MPPT inverter and it's reads out and it look like I don't need to have a remote console so I always carry the remote cancel with me in my camper just like a programming pad and I'm using only when I need to change something. Day-to-day charge level voltage currents I'm using the readout of the inverter. And this pretty much became a maintenance counsel.

I have the Tracer6420AN-ZSWK2 EPever solar controller. This is the correct cable to be able to connect that controller to my PC to configure it for LIthium batteries. I had some questions about how to use it and received excellent support from EPever.

The Solar Guardian app took a bit to figure out when I set it up, but it's nice being able to access the info from anywhere there's cell signal.

Very disappointed this was supposed to be the new update version with the lifepo4 pre programmed in

Funktioniert einwandfrei. Verbindet sich automatisch mit Computer. Sucht den besten Treiber im Internet. Alternativ von der Homepage Epever.

I can now remotely monitor my solar controller and change the battery parrametters without any problems

Good item

Está un poquito complicado pero teniendo un poquito de paciencia se logra enlazar

Fonctionne bien fait sont travaille