[2 Pack] Dual Easy Wing Compatible with Samsung Galaxy S23 Ultra 5G 6.8 Inch Full Cover Film with Easy Install Tool, Case Friendly Screen Protector

It's crystal clear, has a perfect fit, and the fingerprint scanner works flawlessly with the protector on. Moreover, it is compatible with almost every case available on the market, making it a versatile option. Overall, I highly recommend this product for anyone looking for a reliable and high-quality screen protector for their S23 Ultra which doesn't impact the beautiful colours the S23 Ultra screen has.

Installed first screen protector in February. Easy installation and looked amazing. Could barely tell it was on there. 3 months later, it started bubbling up on the sides and lifting as if air was getting into it. The "wings" were perfectly fixed in place and not moving. It seems the screen protector starts to stretch, bubble up and lift. It doesn't seem to reach the middle of the screen but it lifts almost the entire height of the screen. Replaced it in May for the second one and again simple installation, looked great but now, less than 2 months later, it happened again, looks stretched on the sides, "wings" in place but bubbles up and lifts. I've been using the Ringke Fusion Bumper case with it since day one which is supposed to be compatible and none of the sides of the case reach the edges of the screen protector. Clearly there's a problem there with it. Sorry Ringke, you make amazing quality cases and accessories but you should leave screen protectors to others as I'm now currently looking to replace this bubbled up one with another brand. Hope this helps explain what may likely happen in a few months time if you go with this screen protector.

Clear instructions, easy to apply after cleaning screen, I used a bright light to help remove dust etc. Take your time and you'll end up with virtually no air bubbles. Screen and biometrics all working as they should. Would have liked another screen cleaner to go with the 2nd protector but other than that so far so good.

Third Update: 04/09/23 DOWNGRADED TO TWO STARS. The right side of the screen protector (full length of the largest wraparound wing) has lifted from the screen causing multiple bubbles that slowly seep inwards towards the centre of the screen & then this affects the fingerprint reader. I was able to use the microfiber squeegee that came in the package to remove the bubbles but the problem seems to have been caused by the plastic that the screen protector is manufactured from actually stretching, the wing itself is firmly in place. The solution to remedy this fault other than replacing the entire screen protector was to use the plastic toothpick that came with my Victorinox penknife & gently prise up the wing, then squeegee the wing back in to place, this removes the excess stretched plastic from the screen. It's been about a week and so far no repeat of the bubbles. I've just had the same problem with the small wing at the top right, so carried out the same repair..... See how it goes. I honestly WOULDN'T RECOMMEND this screen protector now, it has a fundamental manufacturing fault causing the plastic to stretch and I can only assume it's caused by heat from being in my jeans pocket. (This is the first screen protector, I still have the second to use) Second update: 01/06/23 overall the original screen protector is in perfect condition, but at the top left corner the screen protector has very slightly lifted on the edge, it's been like this for a while now & hasn't gotten worse, it's hardly noticeable tbh. I think it may have caught whilst in my jeans pocket & if you look at the zoomed in photo there are bits of fluff stuck under the lifted edge now, so it's not going to stick back down . The 'wings' that wrap around the edge of the phone body to help stop lift don't extend to this area, if it did probably wouldn't have this problem but all four corners don't wrap around & the others are still perfect (see pic, taken with my old Samsung S10 Plus). I'd still recommend this screen protector, as I can't even see a single mark or scratch on it which is amazing since it's made of plastic. And I do have the spare protector if needed.... Just don't see the point in removing the one on the phone for a hardly noticeable problem. Update: 14/03/23 The screen protector is still in perfect condition & still have a new unused spare. So I'm very happy with my purchase & would as of now buy this item again if needed. I pre ordered the new Samsung S23 Ultra 512gb, so thought I'd purchase a few things to protect my investment. I decided on this Ringke [2 Pack] Dual Easy Wing Screen Protector (I paid £13.99 at time of purchase) as the Samsung S23 Ultra doesn't come with a pre applied screen protector as my previous Samsung S10 Plus did. The fitting of this protector is a little involved, the instructions are on the back of the packaging, I took a pic on my tablet to make reading/following the instructions easier & I also watched a video on the Web. The most beneficial thing I can say about fitting this screen protector to the phone is read the instructions carefully & watch the video, take your time preparing to carry out the task, preparation is 90% of the task. The pack contains two protectors, the first one went on perfectly and it looks great on the phone (can't even tell it's on) I did make sure to use the microfiber squeegee to remove any and all lines/tiny air bubbles of which there were hardly any. The wings are a great idea, slightly wrap around the sides of the phone to prevent lift. Screen touch sensitivity is in no way affected (but you can increase this in phone settings) but not necessary at all. The S Pen works perfectly also. Any finger marks wipe easily away. It's a great screen protector, but you need to read instructions & watch the video before installation, just take your time for a perfect installation.

Good quality but very complex installation instructions. Last thing I need is pay 100% premium on a screen protector and then spend 30 mins on installation. Ended up wasting one of them and see the results in the picture attached.. Nope ...

With patience this really is a 10/10 screen protector the wings make it so the case won't take it off and the clarity seems to be top notch. The bubbles will dissolve in max 48 hours so don't expect final results in 5 minutes. Perfect on my s23 ultra.

I was thinking this would be an easy-to-apply clear screen protector that covers the sides of the phone too. However, the instructions are confusing amd not clear. There are 4 numbered stickers that signify which part of the protective film needs to removed, and for some reason only tab 4 had numbering presented clearly. Tabs 1, 2 and 3 either had them numbering missing, or it was etched extremely faintly into the tab itself. The cutouts for the holes in the tab which fit into the holder are too small and it was just frustrating to apply the screen protector. It's also a blue/green colour and not clear, which is strange. Promised a lot but was let down by the poor instructions and too fiddly to apply.

The one I got was actually the wrong size for the phone. There was no chance of it fitting in my Onyx case properly as it actually went below the bottom of the phone! As for the blue middle bit that is supposed to split in two when installing the actual protector I wish anyone else the best of luck, as it simply will not come apart by simply using the tool provided. I then thought OK I will take it off the protector and do it manually, where upon it tore! I give up on film protectors for the S23U. They are all a complete nightmare to fit and most often the installation process doesn't work properly. Because of the wings it is worse than most and the wings never go down the side of the phone without lifting or bubbles.

Es la mejor mica de hidrogel que puedes encontrar si tienes planeado utilizar todos tus accesorios de la marca Ringke. La colocación es fácil siguiendo las instrucciones del video, como dato extra si colocas la mica durante la noche e introduces el móvil en una bolsa libre de polvo para dejar "secar" el adhesivo durante la noche, evitarás que se adhiera polvo y suciedad en los bordes de la mica recién colocada, consiguiendo una adherencia perfecta y mucho más duradera, evitando así que se comience a despegar de las esquinas por culpa del polvo, o por fricción con el case, esto me ha servido demasiado. Por otra parte es cierto que la vida útil es algo reducida de aproximadamente 2-3 meses, pues durante este tiempo el tacto sobre la pantalla es muy suave (también para el stylus) y con un buen grado anti-huellas, después de este tiempo el film comienza a sentirse un poco más áspero, este tiempo puede reducirse si acostumbras a limpiar la pantalla con alguna sustancia abrasiva como alcohol u otro desinfectante, la mejor opción para prolongar la sensación suave del film es limpiar con una toalla de microfibra en seco o ligeramente húmeda. Como comentaba al inicio el mejor resultado es usarlo con una funda de la misma marca, en mi caso cambie a una funda de la marca Nillkin que es la que muestro en la foto, y como pueden ver, esta funda desprende (levanta) las orillas de la mica (wings) permitiendo el ingreso de polvo, supongo que por ser más rígida y estrecha que las fundas Ringe, así que regresaré a la funda de la marca. Por otra parte es importante mencionar que cubre totalmente el espacio de la cámara frontal, lo que puede ser algo bueno o malo según tu criterio, sin embargo, en mi experiencia es bueno, pues evita que se acumule polvo como en las micas que si tienen ese orificio, en comparación con las micas de cristal templado también es superior, pues aquí no tendrás el horrible círculo de la huella dactilar que tienen esas micas, ya que al ser el film tan delgado permite por sí solo el funcionamiento perfecto del lector de huellas. En conclusión, si deseas conservar el brillo y la sensibilidad táctil de tu pantalla, esta es una excelente opción, teniendo en cuenta que es una protección premium de un costo considerable y que tendrás que renovar periódicamente según el cuidado y uso que le des a tu móvil.

It is unfortunate that there is no good tempered screen protector for the S23 Ultra that doesn't require UV Glue . Luckily the Ringke Dual Easy has come to the rescue! I used to use this series on my S10, and it was the best when the coating of the plastic is fresh. The fluidity matches that of glass, but be aware that it won't last forever. Such is life, good things can't last forever. Overall it is good for the money.

Just bought my second set, after a year of use the protector gave way. There was a tear in the protector after an accident, but my screen was totally fine! Good installation, there will be a line in the middle of the screen for a few weeks, but that and the bubbles will go away. I did find that for the last months the sides would peel a bit loose in my case, but i fixed it with a tiny bit of tape over it, because it's on the back of the phone and in my case i didn't see anything from that fix. I really do love this protector and how amazingly you can install it with ease, especially if you follow the video here on amazon. For now my go to protector, no fuss with fingerprints or camera's. I love it.

I have gone through a long process of selecting the right screen protector for my phone but I made the mistake of reading the reviews and watching youtube videos about the matter of fact. I came here to write an honest report and would like to say that if you can apply this thing properly and it's really easy to apply with the right pressure on the screen with the included sqeugy* (sorry for the spelling) then you can get a really nice applied screen protector. Highly recommended.

It's not bad and definitely better than other alternatives. Here is the problem tho. The material is very stretchy and grippy which not good for a screen protector as it hinders finger sliding especially if you play games on your phone.