DieseRC 433Mhz RF Wireless Remote Control Switch AC 220V 230V 240V 10A 2CH Relay Receiver with 2 Transmitters for Garage Door Electric Curtain Motor Light DIY Radio Control Switch

I had an old garage door opener which I could no longer get a replacement key fob for. This one was easy to wire in and has versatile programming of the key fob buttons on the receiver. Works a treat.

Using this for my garage door. The board is smaller than I expected. The wire terminals are quite small and you will struggle to connect in two thick cables. Comes with instructions, shame there isn't an option to buy 5 remotes with it. I bought three dieseRC programmable ones.

The remote-control switch was ideal for what I was looking for, as it was needed for a built-in electric fire, that had a flame effect and heating, which was controlled by a remote control. The ability to control the heating side of the fire was not working anymore from the original remote control and was found to be an internal problem with the microcontroller in the original unit. As the unit had no manual switches to control its operation, I needed to either install manual switches or a remote-control device to control the fire. I came across this device on amazon and thought it would be ideal for the job. Installation of the new device was fairly straightforward once you have fathomed out the way the device works from the instructions provided. Programming the functions was very straightforward, as I needed the toggle operation for the job in hand. The most difficult part was installing the wiring to the device, the connections for both the mains input and the outputs from the relays were just too small to install the correct gauge of wire into them. In the end I had to use solid insulated wire, the twin and earth type used for permanent installation in walls. So that was my only gripe. If the manufacturers could make these connectors larger, it would make it far simpler to install. But overall, a good little unit and now working well!

Rubbish , one remote is faulty

Switching on and off very poor best I can get to on approx 4 .5 m. To off position best l can get 2 metres would not buy

Great replacement for my roller garage door controller / key fobs

Used to convert shutter to remote control. Easy to install

This is a very useful controller; I needed to convert a sofa with an electric leg support from a pair of buttons on the side to one that would work with a remote fob due to my wife having a serious injury and limited movement. For functionality this was perfect but there are some major issues that make me say that there is no way that this has passes CE compliance. The unit uses mains voltage to power the circuit, I would expect a solid state fuse for safety however far worse, the case does not have a cable restraint and the hole for the mains cable is large enough for small fingers to get in and touch the live connectors. I got around the ingress problem by installing the entire unit within an IP 66 connection box and adding an inline fuse inside the box. I would cost pennies to sort these issues out in manufacture and make it possible to have a fully certified unit.

Betrouwbaar

Bardzo solidne wykonanie pilotów i elektroniki. Proste i intuicyjne programowanie trybów pracy. Wykorzystałem urzadzenie do naprawy kominka elektrycznego firmy Dimplex w którym po 10 latach uzytkowania przestał działać prawidłowo pilot i odbiornik radiowy.

Denemedim ama kaliteli görünüyor

Funkar helt perfekt. Lätt att installera

Fonctionne très bien, comme décrit. La porte de garage est réparée pour quelques €.