Rough Country 2" Black Series Flush Mount CREE LED Lights - 70803BL

I have ordered three sets of these so far. I have used them as reverse lights on my trucks. They have not failed. I wired one set to the switch and one set to the reverse light and the switch. I will wire this ne set to the reverse light and the switch as well. These are comparable, if not brighter than some of the more expensive lights out there.

I’m using these as reverse lights in my 4runner. They fit well the harness is very nice though I didn’t use much of it. Very nice especially with my tinted windows.

Great lights quality switches if you like 2 way switch that has constant 12v power Even when vehicle is turned off! Very bright seems decent quality after 1 month so far! The biggest issue is that RC does not provide enough wire to reach rear bumper from battery! I had to extend the wires. Pain in the @$$! Otherwise I like the lights a lot!

I ordered the wrong version these are spots. Since I meant to install them in the rear bumper I should have ordered floods. I have the A-pillar spots on the front of my truck and they put out a ton of light. So no complaints, haven't installed these yet to cold and no angel grinder.

Got here on time, wiring harness was good quality and it did come with hardware so that was a plus! I went ahead and painted them matte black they have like shiny black to them I mounted them to my back bumper on my 15 ram but had to add about 8ft of wire (18 g) they are super bright overall great spot lights for the money

oem

I got these in March. I put these into my metal bumper. I squared and taped off my bumper. I used a drill for the initial hole into the bumper then cut the square out with my jigsaw equipped with a steel cutting blade. I ground away the sharp edges and mounted the lights. I also drilled into my dash to put in a different switch (also pictured). I gave one star for the install only because not too many folks are savvy enough to cut into the bumper of their $50k truck.

Lights are great but they could have put some kind of Fastners with it you get nothing to put in the 8 holes to mount and the temple is small so be careful when cutting and if you want a gasket around it you’re out of luck, not good against paint !! You’ll half to get a few more things to do the job correctly.