Bohning 1309 Ferr-L-Tite

Er kann ja für irgendwas gut sein, aber für Pfeilspitzen sicher nicht. Alle drei geklebten Spitzen haben sich recht leicht gelöst, normale Zielmatte. Es gibt deutlich bessere Heißkleber, wie den, der im Geschäft (robbow) verwendet wurde. Die Spitzen halten bis heute. Oder wenn man die Spitzen f<r die Ewigkeit kleben möchte, dann Schwanheimer. Der hält alles aus.

Works just like the good old-fashioned stuff. Keep in mind you melt it with a lighter and when you take away the heat it solidifies. If you applied it thin enough it will remain partially flexible, so it would work on hip waiters or boots.

Good stuff, easy to use on gas stove.

Nunca me llego; lo regresaron almmomento de llegar a la aduana. No obstante ya habia comprado otro igual, antrs de este último. Y no me han reembolsado mi dinero!

I'm really impressed with this hot melt. I have had serious problems getting inserts to stay in Victory arrows when using 2 part epoxy, and an even worse time getting iron will collars to stick to the outside of the shaft. I was having to sand, scuff, clean etc. etc. to keep my components in place with epoxy. Enter this hot melt. This stuff is awesome and has held up great on a dozen Victory arrows. For best application I get the insert warm and heat the hot melt with a candle or torch until it's as thin as possible without dripping off the end of the stick. Put the insert in quickly while spinning slightly and you're done. I dip the end of the arrow into some ice water and then give 5 minutes or so to fully set up and they're good to go. The arrows have been shot into block targets, bag targets and Reinhart 3d targets and nothing has budged. I'll be using this from now on.