Manual Ring Roll Bender PR-3 | 3 inch Min. Diameter Roller for 1/4 inch Round Bar and 1x3/16 inch Flat Bar | Hand Crank Design for Chandeliers, Plant Holders​

Item is as described, well built, except handle is in two pieces, probably for packaging purposes, but a little welding will fix that! Delivery was prompt. Great tool for bending and making circles with round and flat stock for x-mas decorations.

Rolled a pair or 4 1/2 ID rings using 1x1/8 A36. Simple enough! I used a file to cut a nick in the adjuster knob so I could count turns and get back to a previous point of adjustment. Very helpful. If you want to make multiple rings cut multiple pieces of stock and run them all through, one pass each before you adjust the knob. This is a low cost tool so don’t expect too much. If you are working around your house and need a part now and then it will do fine. If you are planning on using this tool to make money with it it will probably drive you nuts! I recommend it for the homeowner.

Works great! It would be nice if the rollers could fit 5/16” or 8 mm diameter material.

The only real thing I have a problem with is the handle it comes in two pieces, I ended up having to weld it to keep it from untighting. The second problem with the handle is the rubber part on the end is fixed, and it rubs in your hand as you twist it. Rubs blisters in your hand as you work it, its low geared, so you spin the handle numbers times. It needs a spinning grip. Other wise good quality machine.

Works fine but be aware that the 1” is as wide as this can handle, and as for thickness, less than 1/8”. Other than the limitations on this roller, it’s well made and does (just) what is advertised. Would recommend it on its quality built.