Bohning 1309 Ferr-L-Tite

Works just like the good old-fashioned stuff. Keep in mind you melt it with a lighter and when you take away the heat it solidifies. If you applied it thin enough it will remain partially flexible, so it would work on hip waiters or boots.

I'm really impressed with this hot melt. I have had serious problems getting inserts to stay in Victory arrows when using 2 part epoxy, and an even worse time getting iron will collars to stick to the outside of the shaft. I was having to sand, scuff, clean etc. etc. to keep my components in place with epoxy. Enter this hot melt. This stuff is awesome and has held up great on a dozen Victory arrows. For best application I get the insert warm and heat the hot melt with a candle or torch until it's as thin as possible without dripping off the end of the stick. Put the insert in quickly while spinning slightly and you're done. I dip the end of the arrow into some ice water and then give 5 minutes or so to fully set up and they're good to go. The arrows have been shot into block targets, bag targets and Reinhart 3d targets and nothing has budged. I'll be using this from now on.

This stuff works great you just hate it put a blob of it down inside of the arrow shaft or in your fishing rod end it can be used for both and put it on and there you have it just don't get it so hot that if you try to mold it with your fingers you'll get burnt just use common sense

Does a great job for points that are going into foam butts, but when the point embeds in wood or something difficult to pull out, the point will separate from the shaft when you try to pull it out.

Excellent adhesive, works great

Did a homemade arrow yesterday and this stuff worked great to hold the arrowhead in place. It was steel on oak and it was even strong enough to fill the small gap and still hold it securely. Easy to work with and great results, doesn't even take a lot. I think I used about 1/50th of the bar and I had some overflowing the notch. Shot the broadhead at the target, held tight with 0 movement. Where can I buy in bulk?

They work great for putting in and taking out CRT lenses, I have used this product for years, like the orange color to find on counter

Great product. After researching a lot of glues for my field points, I went with this one and am not disappointed. I am a novice when it comes to archery, but was able to apply my field points and haven’t lost a single one yet. Will reorder in the future.

Er kann ja für irgendwas gut sein, aber für Pfeilspitzen sicher nicht. Alle drei geklebten Spitzen haben sich recht leicht gelöst, normale Zielmatte. Es gibt deutlich bessere Heißkleber, wie den, der im Geschäft (robbow) verwendet wurde. Die Spitzen halten bis heute. Oder wenn man die Spitzen f<r die Ewigkeit kleben möchte, dann Schwanheimer. Der hält alles aus.

Good stuff, easy to use on gas stove.

Nunca me llego; lo regresaron almmomento de llegar a la aduana. No obstante ya habia comprado otro igual, antrs de este último. Y no me han reembolsado mi dinero!

after spending all the time to put the tips in my arrows, they did not keep the tips in. I went back to glueing in the tips