VCB14-F030 Automatic Water Pressure Pump, Multicolour

I had a problem with my washing machine — the incoming water flow was very weak, which made the wash cycle take almost 2 hours, and even then, the clothes weren’t getting cleaned properly. The service technician recommended installing a pressure pump, and I decided to give it a try. The difference is unbelievable! 💧 The water force is now perfect, and the wash cycle time has been reduced from 2 hours to just 1 hour — exactly half! The best part? It’s completely silent! I honestly expected a motor sound, but there’s zero noise — not even a hint of it. You wouldn’t even know it’s running. Just make sure you get a good plumber to install it properly and in the same direction as I’ve done. Once installed correctly, it works like a charm. I’m genuinely happy with this product — powerful performance, total silence, and super-efficient! Highly recommended! 👍

Working well.. Very good, small in size and very less noise.... But no automatic switch... I have to switch on, when i need and switch off, when do not need,otherwise it's always on and will consume electricity..... I heard that it comes with automatic, like when water run it starts and when no use it is off... But it is not like this... But ok I put on when i go to take bath or any other use like washing machine use...

Here’s a polished version of your review: Writing this review after 2 years of use. The unit has been installed outdoors and has been exposed to direct sunlight and rain throughout this period. It is still working perfectly fine, which speaks well about its durability and build quality. One observation I’d like to highlight is regarding the Automatic mode. Occasionally, the motor continues running even when no tap is open. Ideally, in Automatic mode, the motor should operate only when a tap is opened and stop once the water demand ends. Apart from this issue, the Manual mode works flawlessly and has been completely reliable.

Dear Team, I am writing to report two major issues with the motor I purchased on 16 April 2026: 1. *Missing operational modes*: The motor does not have the three modes shown in the product video: manual, off, and automatic. Instead, only a red push button is provided, as seen in the attached photos. 2. *Low water pressure*: There is insufficient water pressure in the kitchen and washrooms, which are the primary areas for which the motor was purchased. Due to these issues, the product does not function as advertised and fails to meet our basic requirements. I am not at all satisfied with its performance. Since the 10 day replacement window is still open, I request an immediate replacement with a properly functioning unit that matches the advertised specifications. Please confirm the next steps at the earliest. Thank you.

This product does its job perfectly. I was having issues with my geyser not providing enough water pressure, which made it difficult to take a warm shower. I honestly didn’t expect it to work this flawlessly. The automatic mode consumes virtually no power when idle- it only draws around 120 watts once the water starts flowing. This makes it efficient enough to run on an inverter without overloading it, which is perfect for my use case. The build quality is excellent—it’s solid, heavy for its size, and feels very durable, especially for the price. It has significantly improved my water flow to just the right level, and there’s been no leakage at all. Just make sure to use Teflon tape when tightening the pipe connections! One thing to note is that it doesn’t come with a mounting bracket, so you’ll need to figure out your own mounting solution while following the guidelines provided in the manual. I haven’t tested it directly with an overhead tank output, but when used with my geyser, it delivered exactly the results I wanted. Overall, it’s absolutely worth it for the performance and value it offers.

This product is working. It increases pressure. Automatic function with red button works well. But it heats up too much while in function. When you open the hot tap of geyser, it starts in 5 seconds, when you close the tap it closes. BUT, if you open the cold tap first (not connected with pump), and then the hot tap(connect in line with pump), the pump will not start at all. Anyways for now it’s fine and manageable but i really doubt the quality of this Chinese product. The excessive heating will surely fail this product in some time. I think its better to go with CG one. Also its seems like a use n throw type product. Bought in 4k.

Was having very low pressure on taps/shower, installed this and now there is perfect pressure. Installation was super easy and the motor is not nosiy. Activates instantly since it's automatic, no need to wait for pressure increase.

One star less because automatic switch not working/liting. Several other reviews saying the same. I think they selling with some discount, knowing this fault. So no point of return the item for that. Pump is working smoothly. Very less unrecognizable sound. Pressure as expected. Install it exactly as shown in photos otherwise it will stop working within some weeks. NEVER dry run (without water). You should install the pump directly between the pipes, that's why it's called inline pump, no other setup is needed. But if you want, search on amazon for "Q1 Beads 2 Pack 8 inch Metal Heavy Duty clamps" to buy. (the base clamp is 8inch and side support is 4inch in my photos, but you can install 6inch to the base)