OEMTOOLS No-Spill Coolant Funnel Kit, 15 Piece Fluid and Oil Funnel Set, Allows Access To Hard-To-Reach Radiators

It is a funnel, a big funnel and works as intended!!!! The kit have multiple adaptors for radiators and radiator caps so you can refill the radiator after flushing the coolant and allow the trapped air to move out of the system, it worked perfect on my Jeep JK 2010 allowing me to refill the radiator after doing flush of the 5 year coolant in minutes. The size of the funnel helps with spills (a word of caution, pour the engine coolant slowly as it will splash back if you fill the funnel too fast as air comes out of the radiator) and the extension adapters are useful to locate the funnel on a clear spot if is needed (I did not use them, so I'm not sure how tight the fittings are or if they are strong enoug to hold the funnel straight).

Perfect fit on a Honda pilot no leaks. Worked great. Great quality.

This funnel works and has a lot of adapters for various radiators. For my application (Lexus GX 460) I got my needle nose pliers and put a very slight bend on one of the tabs for a perfect fit. I wrapped a shop rag underneath and around the radiator's filler neck and performed the refill procedure. The yellow stick thing is a plug that you won't use until the radiator won't take any more coolant so when the thermostat opens it can feed from the fluid in the fill funnel and won't burp out all over the place. Simply insert the stop plug into the funnel and remove the funnel from the fill neck. It's super easy and you'll like it. No more mess. 👍 I highly recommend it.

Nice and clear to watch the bubbles. It has everything you need. It did the job well on my 2018 Honda Accord and should work for almost any car. It really is no-spill, and didn’t even drip when I removed it. Con: The radiator cap metal tabs are a little too tight (they are bent inward too much so the cap won’t easily go on), but I was able to force the cap to slide on and off by hand. I used the “small cap” that matches my OEM cap, but I checked the medium cap to verify and it has the same issue. The large is way too big. So the “hard to put on” fit is a manufacturing issue.

Exactly as advertised. The various parts fit well with each other. The functionality was on par and made the job considerably easier. A worthwhile buy for the price.

I saw this on the Car Care Nut channel and bought it by clicking the link in his video description. It was time to change the coolant in my 2grfe powered Highlander so I bought this set. It would have been pretty tough to do it without this due to the special procedure required to bleed the system. Using this I was able to do it right the first time. Both this funnel system and the Car Care Nut's procedure worked well. All the parts fit inside the funnel for storage. I separated them by type into a couple plastic storage bags, put them all in the funnel, snapped the lid on it, and hung it on the shop wall ready for the next low mess coolant change.

Works great no loss of coolant. Burped rad just fine.

Good product. Easy to use,

Habe das Trichterset bisher zwei Mal angewendet. Bei einem BMW 316i E46 Bj. 2004 und bei einem Honda Civic VIII Bj. 2007. Ich habe bei beiden Fahrzeugen den Kühlerfrostschutz gewechselt und den Trichter zum Befüllen und Entlüften verwendet. Ich bin bisher sehr zufrieden mit dem Trichterset und kann es jedem der an Fahrzeugen arbeitet empfehlen. Man muss nur sehr vorsichtig sein, wenn man überschüssiges Kühlmittel wieder zurück in einen Behälter geben möchte. Einerseits sollte man den langen Stöpsel/Stift nicht fest einstöpseln. Nur ganz leicht einsetzen. Sonst wird es schwierig beim wieder Herausziehen und es kann dabei einiges an Kühlmittel danebengehen. Andererseits muss man gut aufpassen, dass man sich nicht verbrüht, weil das Kühlwasser beim Entlüften sehr heiss wird. Beim Umfüllen des überschüssigen Kühlmittels, kann es nach dem Herausziehen des Stöpsels und durch unachtsames Vorgehen zu Spritzern kommen. Während dem Befüllen und Entlüften sollte man auch aufpassen das kein Schmutz oder Sonstiges in den Trichter gelangt. Hierzu kann man den mitgelieferten Deckel ob leicht ansetzen oder vielleicht ein Tuch darüberlegen. Trotzdem bin ich sehr zufrieden und würde es wieder kaufen.

Muito funcional

Perfect kit. All the adapters worked for my applications, and works excellent to burp the cooling system especially for cars with expansion tanks such as Subaru WRX STI and Hyundai sonata. Makes the job so much simpler and efficient.

it's worth the price nice item

I own multiple cars and haven't come across a fitting provided that doesn't fit yet. Doesn't leak and works great