Front Load Washer Tub Bearings & Seal Kit for LG & Kenmore etc Replace 4036ER2004A 4280FR4048L 4280FR4048E 4036ER4001B Rotate Quiet Deep Groove Ball Bearings

Ordered these because we thought the bearing was going out on our washer, turns out it wasn’t. But we replaced them anyway. It was nice to have the quickly, and easy to install. Months later and they’re still running great. We have 6 people in our house so we do a lot of laundry.

Fast delivery, fit like it should,.habe been running for 3 months without problems

A+

Arrived with some rusty looking marks on the edge of one of the bearings. Hopefully that’s not an issue down the road. Much cheaper than the factory parts. Replaced the bearings in my lg washer.

It fits well and works well. Only problem is it was working for only two weeks until started making noise again. I checked and the bearing is gone.

These bearings are sealed. Oem bearings are not. The bearings fail because the shaft seal fails allowing water to enter the oem bearings. I expect the seal included with the bearings will fail because the shaft is now pitted. It will leak but the bearings should hold up.

This bearing is a lot of work to replace it worked for about 50 loads and started making noise and needs to be replaced again save your money by OEM

Just what I needed and fit perfectly

FUNCIONO BIEN PARA LAVADORA LG. COSTO TRABAJO QUITAR BALEROS USADOS

Both new bearings fit well perform well in the initial wash. The parts are not of top quality but they are of decent quality given the low price. The water seal looks OK. The tub gasket is too big for my LG model WM1333WH My original LG parts LASTED 16 years. The drum-side bearing (large one) failed because the seal failed first. Water got in and the bearing rusted and failed. The small bearing was just fine but it had to be removed so that the large (bad) one could be removed in my situation. Basically, the bearing quality is not critical. A bearing lasts as long as the water seal last plus one year. Because it SO HARD to remove the bearings from the drum, I would inspect and replace the seal every other year. If you drain the residual water at the water pump clear-out and the water has rusted color, your water seal is shot.

It just take a little courage to take the washer apart. Not a hard job, did it in about two hours start to finish.

Worked perfectly.

I installed these bearings in December 2023 and they are already failing. I will have to replace with a higher-quality bearing. Very disappointed with this product.