Bob Smith Industries BSI-157H Maxi Cure/Insta-Set Combo Pack (3 oz. Combined),Clear

This adhesive combined with the accelerator is nothing short of AMAZING!!! Nothing worked for reconnecting two fragile pieces of polystone. I tried this product as a last resort and WOW....it was a miracle!!! This is now my FIRST RESORT moving forward!!!!

The glue and spray work tremendously well. I wouldn’t give it less than 5 stars, but, the spay bottle leaked most of the fluid due to a defect on the pumping mechanism. That would be the only thing to look out for!

This is BEST glue I've ever used. I can at least comment on plastic. I 3d print, and used different glues with "Ok/average" success. But I had a big dragon with relatively heavy wings and akward to hold in place while glue dried. I tried different 2 part epoxy from one syringe, and tried "5 minute glue" and when I would try to glue it and do my best to prop up the wing even after hours it didn't seem to hold right. For some reason I tried this, "unknown" glue and OMG. I put a tiny glue in the whole of the wing and spray the "activator" on the male part of where the dragon wings attach and I place them together and LITERALLY 10 seconds it's hard, within a minute it's permanent. I'm AMAZED. I've used it on many different projects and it lasts a long time. This was second purchase of it. The ONLY time it's failed is my car window motor broke and window wouldn't stay up. So I tried to line a whole trail of glue on top of window and sprayed rubber part. Held window up for a minute, let go and it was fine. Lasted about a week then window came lose and dropped. I'm not sure if I didn't use enough glue or didn't spray right. Amazingly it lasted for nearly a week after only holding in place for literally a minute. But I THINK it's because I did something wrong, not the rain or heat the only day it was warm 2 weeks ago. Anyways, this stuff is amazing BUY IT if you need glue EVER. And to the creators/seller THANK YOU for making and selling such an easy to use glue.

Had for months. Easy to re-open bottle and use it over and over again. I love the activator spray. Makes wait time almost nothing. Wish I found it sooner. Highly recommend

Glue works good on scale models. I would suggest using a tooth pick to apply the accelerator as the pump is a mess to use. The whip they supply for the glue clogs easy and not worth using again easier to use a tooth pick. The smell is not bad.

Great product!

Have bought this multiple times - by far the best product on the market. Low odor, application is easy, and the product works on almost any surface, especially with the activator! Cures in minutes, so be sure not to get it on your fingers - it is NOT easy to get off! 😂

Why are there not six stars? I first started using this glue at work to glue thermistors to electronics. It worked so well, I started using it at home. It works with everything. And this is the ONLY glue I have found works consistently with plastics. This is a must have in every tool box and junk drawer.

This stuff is magic for 3D printing. Successfully tested with PLA and PETG. Use the spray to eliminate the white hazing during drying.

It’s fast, I used it on broken door trim clips

works great

Sick of super glue hardening in the tube after a few uses? Me too! Bob Smith Industries and their range of products is just the ticket. Non reactive plastic bottles keep the glue ready together with the zip hardener makes whatever job easy and fun.

Bought it since its harder to get the starbond brand here in Australia without paying an arm and a leg for them. So tried this brand and it's super good! The tips are great, and I can't believe how fast it sets when sprayed with the fast curing mist. Just be careful of fingers or skin etc! Trust me, it sticks very easily! Use this for a wooden sign and it's still going strong! Love it.