WOWOW Widespread Bathroom Faucet

Great fit for my vanity. Install was easy enough. No leaks or issues yet. Looks classy and high value.

As described, look great, color beautiful

I just finished a complete Reno of my guest bathroom, and this beautiful faucet has added such an elegant touch to the room. It was very easy to install (64 year old woman), and it works beautifully. I may purchase again when I do my master bath.

We have had this faucet installed in our half bath for almost 4 years now and it gets plenty of daily use. First thing I will say is do not invest in any black colored bathroom finishes unless you like wiping them down after every time you touch them. The matte black finish will show every drop of water that gets on it. I can’t blame this product for that, it’s just the nature of the finish. This faucet was very easy to install and comes with everything you need except plumbers putty for the drain. It has functioned very well these past 4 years with no leaks or other complaints. Very recently, however, the black coating on the drain has started to peel away, and once it started it was very quick to come off the entire thing leaving the steel color underneath. This has not occurred in any way in the faucet, just the drain. For this reason I gave it 4 stars, however for the price of the item I would still say it’s a very good value. We will be replacing the entire faucet/drain very soon due to both the peeling and the high maintenance of the black finish.

i installed it myself so its pretty much ready for the novice

Nice.. as advertised Slim profile Good value

love it, has some quirks but looks highend, like plastic inards and it has a 'stop drip' that goes for a few seconds but it doesnt leak, the areator masks that pretty good but removed you see it, and i'll keep it removed except with guests over with hard water .. ok to the install skinny, with care it'l be flawless, comes with everything and then some - - the drain works fine with careful mods if your pretty handy .. most sinks will be set far back so a couple of preps need to be done, So start with the fixture itself, no need to disassemble, if you have a dremel from the underside, use a wore out stone about 1/4" thick to drift the hole back towards the shoulder of the bottom, dont go past that .. do the same thing with the bottom plate gasket, drift it over to touch its shoulder edge then stop ... now mock it up on your counter top and figure out where your at, straight and whatnot ... now get the pull rod and some type of grease, any will do .. just put a very small dot on the very end ... drop it through the hole, it will be 'slightly' still tilted back to miss the edge of the gasket, you want that so dont get any ideas lol .. slightly tilted back and straight side to side is good, just twist it to leave a little spot of grease to mark where it is on the counter .... now get your drill and a 1/4" bit and do it .. if you did it right the hole will be under the base and inside the outer edge of the gasket so will be hid with any future changeouts, and wont leak without a flood on the counter anyway .. finally the drain actuator rod may need to be cut, mine hit the wall so trimmed it a bit, but with careful placement of the pull rod adjust points i managed to get a solid feeling jiggle-free pull rod that fits ... - other assembly notes are with the drain pipe use the teflon tape 'TWO WRAPS' each at the very top of the threads and just below the overflow cutouts with the seal pulled down below it then pushed back up over it ... under the drain top you need a bead of silicone 'in the corner' all the way around about the size it would be coming out of a caulk gun with no tip 3/8" or so, nice big fat one .. - just to say it, the inner assembly 'is' plastic so i'd use reserved horsepower tightening both the hold-downs and the lines ..

Product went in with ease and allows for a lot of forgiveness. Ours was going in a new bath vanity install on marble and looks fabulous! Great product, installs as easy as it can for upside down looking up into 3 small holes with dust falling down. You will need a second set of hands to hold them straight as you install them from the bottom. Or you can make a jig to hold them in place while you work beneath if you’re working alone.

Cumplió con su función y se instaló sin ningún problema.

J’ai installée ces fauchets (x2) dans notre salle de bain principale. Après deux ans ils sont toujours en très bon état. Leur aspect est très beau. Le rapport qualité prix est excellent. Mon conjoint dit que l’installation était relativement facile. Je recommande.

Exactly as expected. Easy setup (removing my old one was harder than installing the new one). It looks great in our bathroom. Only complaint is that the sink stopper is shipped with a protective cap over it, and my sink stopper was scuffed from the cap rubbing on it. Otherwise, very happy with the product!

I am in love with this faucet. My existing piping in the bathroom sink was really old so I got those replaced and replaced my faucet too. I have 4 inch faucet and this fit perfectly, and looks so beautiful. The pop-up drain is holding up nicely and no problem there. It completely changes the look of the bathroom and I can't believe I spent less than $100 for the whole thing.